Page 8 - KNK Groove with MTC User Manual

1. Introduction to the Klic-N-Kut

1.01 Unpacking

 Verify that you have received all contents. There is a checklist below. Please notify your KNK supplier
immediately if anything is missing.
 Remove all foam pieces and cut the zip ties carefully before turning on the KNK.

 Use the enclosed test pen as you experiment and become familiar with operating the KNK. Place scrap
paper on the mat and simply draw shapes rather than cut them. This will prevent possible damage to the
blade, mat, and cutting strip as you learn where shapes will cut and the basic operating procedures.
 Do not unplug the USB cable from your computer or from the cutter unless you first turn off the cutter. Doing
so can cause power fluctuations that, in turn, can damage the cutter.

 Always turn off the KNK when not in use. Leaving the cutter turned on for extended periods of time can
possibly damage the machine.

1.02 Contents of Box

Please verify that you have received the following items. If anything is missing, please contact your Klic-N-Kut
supplier as soon as possible.

 Klic-N-Kut Cutter  Testing Pen
 Klic-N-Kut Studio Installation CD  Cutting Mat and Ruler
 1100 Font and 3900 Clip-art CD  Krylon Spray
 Designers' Collection 1 CD  User Manual
 Blade Holder  Power Cord, USB Cable, Serial Cable
0
Blade Pack containing: one 45 red capped Blade
  Alignment Pin
and one Sliver 2 blue cap Blade

1.03 Items to Note (Please Read!)

 Blades: The blades used by cutters are extremely fragile. Do not drop or even bump the blade onto any
hard surface as they can chip easily. When not in use, retract the blade into the blade holder or remove and
cover the sharp end with the soft plastic cap. Be careful to keep these small blades in a safe place.

 Warranty: The one year warranty covers Manufacturer’s Defect only and does not include normal wear and
tear. If warranty work is required, the owner is responsible for shipping costs to and from Accugraphic Sales.
If a KNK is damaged during shipment, then your dealer should be notified as soon as possible. If damages
are reported later than three weeks after delivery, then it will be the responsibility of the owner to ship the
damaged KNK back to Accugraphic for repair.

 KNK owners outside the USA should contact their KNK dealer for procedures regarding warranty work or
shipping damage.
 Transporting: When transporting the cutter, move the pinch wheel levers into the upward position. Remove
the accessories from the KNK and place in a separate bag. We also recommend retaining the original boxes
with the foam inserts in case you ever need to ship your KNK.

 Additionally:
 DO NOT touch or jam the plotter’s track while it is operating. If the cutter is damaged, it is the owner’s
responsibility.

 DO NOT shake the cutter while it is operating.
 DO NOT cut any materials that have staples or other embellishments attached.
 DO NOT touch the cutter with a magnet.
8