Page 10 - KNK Groove with MTC User Manual

1.05 Control Panel 2 1
7 8
3 9

Go through the
various modes below
to experiment with
the settings and 4
understand each
mode. 5
10
6
11

1. LCD Display 7. Offline Mode: moves carriage to the left;
2. Test: Draws a small rectangle when cutter is in Online Mode: increases cutting force
Offline mode 8. Offline Mode: moves mat to the back; Online
3. Online / Offline Toggle Mode: increases cutting speed
4. Menu 9. Offline Mode: moves carriage to the right;
5. Repeat: repeats last cut when cutter is in Offline Online Mode: decreases cutting force
mode 10. Offline Mode: sets the Origin
6. Pause: stops cutting 11. Offline Mode: moves mat forward;
Online Mode: decreases cutting speed

Online Mode Display
v = cutting velocity, mm/sec
f = cutting force (scaled from 50 to 500)

Step 1: Turn on the KNK.

A welcome message will
flash for a few seconds when Increase/Decrease
cutter is first turned on. Then Velocity (Speed)
the cutter will come to rest in
the Online Mode.
Experiment with “+” and “-“
buttons, as shown.
Increase/Decrease
Cutting Force
(Pressure)

Offline Mode Display
x = forward/back distance from origin
y = left/right distance from origin

Step 2: Press the Online
button.
Move the mat
This will change to Offline forward or towards
mode. Experiment with “+”, the back
“-“, Test, and Origin
buttons, as shown.

Move the carriage
left or right
Press the Test button for a Press the Origin button to set the
small rectangle to cut at the origin. Note the cutter will remain in
origin. Note the cutter will the Offline Mode.
then be in Online Mode.

10