Page 255 - Klic-N-Kut User Manual
P. 255
(7) From the Applications folder, launch the MTC COM Bridge program. If you receive an error message, click
on “Continue Anyway”. The following window will open and you should select the connection in the menu
which says “tty.CUTTER”:
Click on Save before Close.
(8) Click on Save and Close.
(9) You are now ready to do the testing presented in Section 1.10. Note however that you most likely need
to experiment with the Data Throttle setting. To access this setting, send a shape to the cut window,
and then click on the small triangle shown below. Then select Advanced Options. You will find a tab to
the right of the Baud Rate Information tab called Throttle Data. Select that tab and try decreasing the
Pause and increasing the ms.
Click on small triangle.
May need to increase to 200
May need to reduce to 1 or higher
255
