Page 195 - KNK Groove with MTC User Manual

 After printing, place the printout onto the mat, in the same orientation you see in the main window and insert
the mat into the KNK. As you are facing the KNK, the printout should be on the mat in a portrait orientation
with the arrow pointing towards the right end cap:

Feed the mat this
direction into the
KNK

Place your printout
on the cutting mat in
this orientation.
Set the origin in the bottom
right corner of the printout,
using the alignment pin.

9.04 PNC Procedure Part 2: Aligning and Calibrating

Aligning the Pin with the Registration Marks IMPORTANT: Set Us and Cut Speeds to 200

 Click on the Cut Project With icon to go to the cut window. If you haven’t yet performed a test cut, do so
now using either the Knife Point or WYSIWYG setting. Perform the test cut in a location that won’t be part
of your final cut or use a scrap of the same material you are cutting.
 After the test cut is successful, move the alignment pin until it is directly over the lower right corner of the
printout, as indicated above. Set the origin.

 Under Cut Type, select Print and Cut:

 Click on Start and the following window will open. Check Fixed Length and enter 11.0”, assuming you set
your Virtual Mat to be 11” in width. Then click on Begin.

 The alignment pin should automatically move to within a very short distance of the first registration mark.
The following window will open:
195