Page 216 - KNK Groove with MTC User Manual

caught on the side of the Groove. If you normally set the laser light at the lower right corner of your
material (because you change your Virtual Mat to match your material dimensions), then place the Post-
it note there. Note that the location of the drawing and cutting will be aligned with one another perfectly
but may be slightly different from the location on your Virtual Mat. Thus, take that into account so that
the shapes are not drawn nor cut off your material.

Align cardstock in same Place Post-it note at bottom
manner as you normally do right corner of grid OR at
when using WYSIWYG Cut
Mode. bottom right corner of paper if
you changed the Virtual Mat to
match paper dimensions
versus actual mat dimensions.

 Move the laser light to the exact location of the blade puncture (NOT the gel pen mark) and set the
origin.

1. Place laser light or 2. Insert the gel pen into the
alignment pin directly cutter. It is now in the correct
over puncture from location for drawing.
bladeholder.

 Select the layer with the shape(s) to be drawn and execute the “cut.”
 Move the laser light to the exact location of the gel pen mark (NOT the blade puncture). Once you have
it directly over that mark, set the origin.

1. Place laser light or 2. Insert the blade holder into
alignment pin directly over the cutter. It is now in the
mark made by gel pen. correct location for cutting.

 Select the layer with the shape(s) to be cut and execute the cut. The resulting gel pen lines and cut will
now be aligned:

216