Page 32 - KNK Groove with MTC User Manual
P. 32
Enter width and height Measure the actual width
that you entered for and height by measuring
W: and H: with a ruler. Be as accurate
as you can.
Note that it doesn’t
Click on Calculate after matter which units are
entering the measurements used. Just enter mm
even though it shows in.
Click on Calculate and the following window will open asking you if you want to accept these numbers as
your new resolution numbers. Answer Yes and then test again. Now, if either number is significantly
different from 1016 (more than 1030 or less than 1000), you may have made an error and you’ll want to re-
enter your values again.
Answer Yes to
accept the newly
calculated values
After responding Yes, the Resolution numbers will be updated. If, after testing again, you find that you’re
still slightly off, then just repeat again. If you need to be very precise and you cannot accurately measure the
sides, then you can also just slightly adjust the actual numbers themselves using this as a guide:
Increase X Axis slightly to Increase Y Axis slightly to
make images cut a bit make images cut a bit
wider. Decrease X Axis taller. Decrease Y Axis
slightly to make images slightly to make images
cut a bit narrower. cut a bit shorter.
Click on OK to accept these
values or new values you
manually enter.
32
