Page 31 - KNK Groove with MTC User Manual
P. 31
Set the origin on your paper. Make sure you have plenty of room to draw the square. Click on the Cut
Project With icon (or go to Cut Project With>Klic-N-Kut Series):
Cut Project With icon
H
W
Have your KNK draw the square. Then take a ruler and carefully measure the two sides.
Click on the Cut Project With icon again, and click on a tiny wrench icon next to the Klic-N-Kut Model
menu:
Click on small wrench icon here
A window will open. Click on the Resolution tab and then click on another small wrench icon:
Click on Resolution Calibration tab
Click on small wrench icon here
This window now opens. Enter the dimensions on the screen (200 and 200) and then enter the measured
width and height. Note the Width is the left-to-right dimension as you face the cutter and the Height is the
up-and-down measurement.
31
