Page 28 - KNK Groove with MTC User Manual

Feed the mat this
direction into the KNK

WYSIWYG

 This is the mode recommended when you need to cut shapes in very specific locations on your material
(such as the center front of a greeting card).
 Create a virtual mat that matches the material dimensions. For example, if you are cutting from an 8.5” x 11”
sheet of cardstock, then create a Virtual Mat with those same dimensions. You can use either Portrait or
Landscape mode - just remember to place your material on the mat in the correct orientation for feeding
into the KNK.

 The origin is set using the alignment pin, not the blade tip (refer to Alignment Pin in Section 1.06). Direct
the pin tip to the bottom right corner of your material (see below). Note that if you need absolute
precision for the location of your cuts, it may be necessary to tweak the Laser (Alignment Pin) Offset.

 WYSIWYG– Portrait Mode Feed the mat this direction into the KNK
Indicates
Portrait
mode

Origin set here
using the
alignment pin

Location of shapes on the screen Where shapes are drawn or cut on material

28