Page 180 - Klic-N-Kut User Manual

when the Stretch function is applied. In the following example, the border created in Section 8.06 will be
stretched to fit around a circle:

 After entering the Wrap Objects to Path window, Repeat is checked and increased first. Then, Warp is
turned on:
Turn on Turn on
Repeat Warp

Four borders are The four borders
positioned now bend to hug
around the circle the circle

 Notice that where one border ends and the next one begins (indicated by the green arrows below), the
scallop spacing is greater than between the scallops along a border. In other words, the repeats need to
overlap more so that the spacing looks more even. This is first accomplished by decreasing the
Spacing setting:

Decrease Spacing until scallops looks
even between the repeated borders.

A change in Spacing does not affect the
start and end of the stretch

 However, there is still the same gap between the initial start and end of the stretch, as indicated by the
blue arrow above. This is where the St. Extend setting will correct the gap. By changing it from 0% to
50%, the start and end will now overlap and the spacing is correct:

180