Page 149 - Klic-N-Kut User Manual

Small green arrow indicates
direction of cutting
Option to show Properties of the
size in inches, highlighted part of
Move cursor over outside line cm, or mm the shape
of shape to bring up properties

 Likewise, when you hover the cursor over an outer side of the other star, the solid area of the star will fill
with stripes and the properties of the outer star will be displayed. If you hover the cursor over the inner star,
then the properties of that star will be displayed instead:

Properties of Properties of
outer star inner star

 Note that the Path Area of the outer star includes the area of the inner star. It does not subtract out that
part of the shape. This makes sense with regards to cutting since the same amount of material would be
needed to cut the outer star, regardless of whether or not the inner star were cut. If, for any reason, you
needed the actual area of the larger star, then you could subtract the Path Area of the inner star from that of
the outer star.

 To measure an angle, place the cursor at the point where the two sides of the star meet and drag outwards
along one of the sides. The length and the angle of this side to the horizon are displayed. Then hold the Ctrl
key and bring the mouse cursor down to the outer tip of the other side. The length of this side and the angle
relative to the other side are now displayed:

Length of side is Hold Ctrl key and move cursor
shown, along with the to the end of the other side.
Angle of this side to Properties shown are the
the horizon. Length of the side and the
Angle between the two sides.

 Similarly, the Angle of the other star can be measured and then the full list of properties compared between
the two stars:

149